© Lanta Lighting™ 2016. Terms Apply. All trademarks are the property of their
respective owners. E&OE. All specifications and details are correct at time of print.
October 16 - Version 2
Fireblock Hex Batt WIFI Owner Handbook™
8- DMX Wireless Control
(Wifi Models Only)
The Lanta Fireblock Hex Batt WIFI™ is designed to work with a W-DMX transmitter.
To link, first ensure your DMX desk is connected to the wireless controller and the DMX
settings in the light are correct. (Refer to section 1)
Power on the Wireless transmitter and then turn on the wireless receiver in the Lanta
Fireblock Hex Batt WIFI™ using the separate switch. Press the function button on the
transmitter to start the link process. On first use, the light should automatically search and
connect to the receiver. The Green LED will flash to indicate communication is being
established and then be steady.
Your Lanta Fireblock Hex Batt WIFI™ should then respond to the control signal from your
DMX desk.
Should it fail to connect, or you wish to link to a different controller , reset the wireless
settings in the Lanta Fireblock Hex Batt WIFI™ by pressing and holding the Wifi Reset button
for at least 3 seconds and the green LED goes out. Repeat the link process with the
transmitter, the Green LED will flash to indicate communication is being established and
then be steady.
Connection Status Indication (Green LED)
Continuously Off = not assigned to a transmitter
On 900ms / Off 100ms = assigned to a transmitter, but no DMX present
Continuously On = assigned to a transmitter and DMX present
On 100ms / Off 100ms = link to transmitter lost or linking to transmitter
