© Lanta Lighting™ 2016. Terms Apply. All trademarks are the property of their
respective owners. E&OE. All specifications and details are correct at time of print.
April 16 - Version 1
LED Gyro Ball Owner Handbook ™
Operating Modes
To select the mode of operation there is a 4 button keypad and 4 digit LED display on
the front of the unit. To begin press the MENU button, each subsequent press will progress
through the various settings. UP/DOWN buttons will allow you to scroll in each direction.
Press ENTER to select an option, the UP/DOWN for the required setting then press ENTER
button to confirm. Waiting for 10 seconds or holding down the MENU will return to the main
menu with the DMX address being displayed. If no button is pressed for 30 seconds the
display will turn off.
Auto Run Mode
If there is no DMX signal, in ‘Master mode’ the light will run an auto show and sound mode
will also be active if set.
Press MENU until the display shows “Slnd”, press enter followed by UP/ DOWN to select
“nast” to set as Master. Other lights can be connected and set to slave ‘Sl1’ to run the
same as the ‘Master’ unit or ‘Sl2’ to run a contrasting display.
Press MENU until the display shows “Shnd”, press ENTER followed by UP / DOWN to select
either “Shou” for sound mode or “Auto” followed by ENTER and UP / DOWN to set a speed
value between “SP1” & “SP9”
Press MENU until the display shows “SenS”, press ENTER followed by UP / DOWN to set the
sound sensitivity between 1-100.
DMX Mode
You can control the devices individually via your DMX-controller. Press the “MENU”
button until it shows “Addr”, press the ‘ENTER’ the display will flash and you can then use
“UP/DOWN” to select the required DMX address, then select “ENTER” to set.
Press “Menu” until the display shows “Chnd” then “ENTER” followed by “UP/DOWN” to “3Ch”
or “11Ch” mode. Press “ENTER” to save the setting. Wait 10 seconds, or hold down the
“Menu“ button to return to the main menu.
