8
Chapter 3 Hardware Installation
For POE models: Do not use units POE ports to uplink to another unit. (May Cause Damage)
Lantech strongly advise the installation of a Galvanic isolated DC/DC converter between the power
supply and the Ethernet switch on all Non-Isolated units. Please contact the sales team for advice
on which units support isolated power supply.
Hardware installation
1. Unpack the Industrial switch
2. Check if the Rack mount brackets are screwed on the Industrial switch or not. If the
Rack mount brackets are not screwed on the Industrial switch, please refer to
Rack
Mounting
section for rack installation.
3. To install the Industrial switch in a 19 inch Rack.
4. Power on the Industrial switch. Please refer to the
Wiring the Power Inputs
section
for knowing the information about how to wire the power. The power LED on the
Industrial switch will light up.
*For PoE model, please connect power supply of PoE
before system power. Otherwise, the PoE function will not work correctly.
5. Prepare the twisted-pair, straight through Category 5 cable for Ethernet connection.
6. Insert one side of RJ-45 cable (category 5) into the Industrial switch Ethernet port
(RJ-45 port) and another side of RJ-
45 cable (category 5) to the network device’s
Ethernet port (RJ-45 port), ex: Switch PC or Server. The UTP port (RJ-45) LED on
the Industrial switch will light up when the cable is connected with the network device.
Please refer to the
LED Indicators
section for LED light indication.
