12
3.2 Wiring the Power Inputs
Please follow the steps below to insert the power wire.
Note:
The input power of PoE of IPES-3424DSFP-2P (power input 3) is separated with
power of switch system(power input 1 and 2).
The power input module 2 is optional part.
1. Insert DC power wires into the co and - for power 1, or + and 1 for power 2.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
3. Insert DC power wires into the co and - for power 3 for PoE .(Only for IPES-
3424DSFP-2P)
4. Tighten the wire-clamp screws for preventing the wires from loosing.
