PC Fiberlynx User Guide
PC Fiberlynx User Guide
PC Fiberlynx User Guide
PC Fiberlynx User Guide Lightwave
Communications
Lightwave Communications
Lightwave Communications
Lightwave Communications
2-4
www.lightwavecom.com
The PC/SUN models of PC Fiberlynx (part numbers 200.100.01xx) are similar to the PC-only
version (part numbers 200.100.02xx). The difference is the SUN keyboard and mouse
connection is made using a single MiniDIN-8 cable, rather than two PS/2 cables. All other
devices and peripheral connections are the similar to the PC-only models.
The PC Fiberlynx for PC/SUN Receiver is shown above. The PC/SUN Transmitter is similar.
2.4
Connecting Fiber Optic Cable
1.
Situate the transmitter and receiver units close to their final locations. Run the fiber optic
cable to these locations with enough slack to prevent strain from damaging the cable.
2.
Attach the individual fiber strands to the ST connectors on the back of each unit. Each
strand on the transmitter end should be attached to the same connector as on the
receiver end (i.e., red to red, blue to blue, etc.). Try to use the strand with the color
indicated on the connector; note any substitutions to avoid confusion.
3.
Use the provided strain relief device to prevent damage to the fiber optic cable. The
strain relief ties may be trimmed if desired. When placing the transmitter and receiver in
the final location, be sure to allow sufficient space behind each unit to prevent excessive
bending of the fiber.
Dress Cables to prevent kinks and tangles
Fiber Cables can be damaged if kinked or crushed.
SUN Keyboard/Mouse Connector
