A Lantronix Company
PC Fiberlynx User Guide
PC Fiberlynx User Guide
PC Fiberlynx User Guide
PC Fiberlynx User Guide
15.00.034 Rev. C
2-7
2.6 Connecting the User Peripherals
Like the Transmitter end, both models of PC Fiberlynx receiver will connect in a similar fashion;
the only difference is that the
PC/SUN model
has connections for both PC (PS/2)
and
SUN
computers and keyboard and mice. The
PS/2 Only
model does not have a SUN Keyboard and
Mouse connector; it is shown below.
PCFiberlynx (PS/2 Only) receiver
1.
Place the PCFiberlynx receiver on or near the user station. Connect the keyboard and
mouse to the proper ports on the receiver. If using the SUN keyboard and mouse, the
SUN keyboard is connected to the mini-DIN8 connector, and the mouse connects to the
Keyboard.
2.
Connect the monitor to the receiver: the lower HD15 (
VIDEO OUT
) connector is the
primary video connector. The upper HD15 connector is for an auxiliary monitor; this
monitor will show identical information as the primary monitor.
3.
Connect the audio devices to the receiver. The lower connector, marked “
MIC IN
”, is for
use with a microphone only. The upper connector, marked “
LINE OUT
”, is for connection
to powered speakers or headphones.
4.
Connect the serial device to the receiver. The receiver’s serial port behaves like the DB9
serial port found on the back of a PC, and will connect to any device that would normally
connect to a PC.
5.
Connect the receiver to AC power and turn on the switch. The status LEDs found on the
front of the unit should light.
