Lantronix
x4120 User Guide
33551 Rev. C
Page
39
of
142
Reset to Factory Defaults
If need be, you can reset all configurations in the IONMM back to their original factory defaults. This
operation can be accomplished through either the CLI or Web method.
IMPORTANT
This operation deletes
all
configuration information that was saved in the IONMM, including
the IP address you assigned to the IONMM.
Resetting Defaults – CLI Method
1. Access the x4120 through either a USB connection or a Telnet session.
2. At the command prompt type:
reset factory
.
3. Press
Enter
. The following displays:
Warning: this command will restart the specified card, connection will be lost!
C1|S18|L1D>
All configuration parameters will be reset to their factory values. For a list of all factory defaults, see
“Appendix B: Factory Defaults”
on page
179
).
Note
: Your USB and/or Telnet session will be disconnected.
4. Set the IP configuration (see
“Doing the Initial System Setup”
on page
48
).
