5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference
156
show history
Displays the last 20 commands entered during the
current CLI session.
show log
Displays the email log.
show statistics
Displays email statistics.
subject
<text>
Sets the Subject for email alerts. <text> = text to
placed as the subject.
to
<text>
Sets To addresses for email alerts. <text> = a
quoted, semicolon separated list of email
addresses.
write
Stores the current configuration in permanent
memory.
enable (enable) level commands
auto show interfaces
Show interface statistics
auto show processes
Continuously show thread runtime information
clrscrn
Clears the screen.
configure
Enters the configuration level.
connect
Show name and number for lines.
connect line
<line>
Begin session on serial port.
device
Enters the device level.
disable
Exits the enable level.
dns
Enters the DNS level.
<number>
Enters the configure email level.
exit
Exit from the system
filesystem
Enters the filesystem level.
iperf
<params>
Run iperf with command line parameters passed in
quoted string.
kill ssh
<session>
Kills SSH session with index from "show sessions"
kill telnet
<session>
Kills Telnet session with index from "show sessions"
line
<line>
Enters the line level. <line> = number of the line
(serial port) to be configured.
ping
<host>
Ping destination continuously with 5 second timeout
ping
<host>
<count>
Ping destination n times with 5 second timeout
ping
<host>
<count>
<timeout>
Ping destination n times with x timeout (in seconds)
reload
Reboot system
reload factory defaults
Reload factory defaults to permanent storage
show
Show system information
show history
Displays the last 20 commands entered during the
current CLI session.
show interfaces
Show interface statistics
show ip sockets
Show UDP/TCP state information
show lines
Show line information
show processes
Show thread runtime information
show sessions
Show active Telnet and SSH Sessions
ssh
Enters the SSH configuration level.
ssh
<optClientUsername>
<host>
Begin SSH session on network <host>. The
optClientUserName must match an SSH Client:
Users configuration entry. Use "" in
optClientUserName to prompt for host username
and password.
