1: Using This Guide
EDS-MD User Guide
17
Battery
A Lithium battery cell inside the unit maintains the unit's date and time when the device is powered
off.
Do not attempt to replace it.
The battery is serviceable only by Lantronix.
Caution:
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE
RECOMMENDED BY THE MANUFACTURER. DISPOSE OF USED
BATTERIES ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS.
Attention:
IL Y A DANGER D'EXPLOSION S'IL Y A REMPLACEMENT INCORRECT
DE LA BATTERIE, REMPLACER UNIQUEMENT AVEC UNE BATTERIE
DU MÊME TYPE OU D'UN TYPE ÉQUIVALENT RECOMMANDÉ PAR LE
CONSTRUCTEUR. METTRE AU REBUT LES BATTERIES USAGÉES
CONFORMÉMENT AUX INSTRUCTIONS DU FABRICANT.
Wall Mounting
If wall-mounted units are installed, the following items must be considered:
Do not install the unit in such a way that a hazardous stability condition results because of
uneven loading. A drop or fall could cause injury.
Make sure to install the EDS-MD in an environment with an ambient temperature less than the
maximum operating temperature of the EDS-MD. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum ambient temperature
(Tma) specified by the manufacturer.
Install the equipment on a wall in such a way that the amount of airflow required for safe
operation of the equipment is not compromised.
Maintain reliable earthing of wall-mounted equipment. Give particular attention to supply
connections other than direct connections to the branch circuit (e.g. use of power strips)
because of the effect that overloading of the circuits might have on overcurrent protection and
supply wiring. Appropriate consideration of equipment nameplate ratings should be used
when addressing this concern.
Before operating the EDS-MD, make sure the EDS-MD mounting is secured.
Port Connections
Only connect the network port to an Ethernet network that supports 10 Base-T/100 Base-TX/
1000 Base-T.
Only connect device ports to equipment with serial ports that support EIA-232 (formerly RS-
232C).
Unless specified otherwise, only connect USB ports to USB thumb drives.
Warning:
To avoid overloading and overheating, do not use a USB port as a
charger port or a power port for other devices such as a cellular phone,
PDA device, disk drive, etc.
