1: Using This Guide
EDS-MD User Guide
18
Equipment Classifications
Classification according to the type of protection against electric shock: Class I Equipment
Classification according to the degree of protection against electric shock: No Applied Parts
Classification according to the degree of protection against ingress of water: IP20
Classification according to the mode of operation: Continuous Operation
Environmental Conditions for Transportation and Storage
An ambient temperature range of -30°C to +80°C
A relative humidity range of 0% to 95%, noncondensing
An atmospheric pressure range of 50 kPa to 106 kPa
Cleaning Instructions
1.
Disconnect all cables and unplug ac power from the device.
2.
Prepare a disinfectant solution using 1 part bleach mixed with 9 parts water.
3.
Lightly moisten a tissue with the mild detergent and wipe down only the outside of the device.
4.
Allow the device to air-dry or wipe dry with a clean dry tissue before use.
Caution:
To avoid electric shock and for the device to work properly, do not allow
cleaning solution get inside the device, specifically the interface port
connectors or the ac inlet. Do not immerse the device in any liquid.
Electromagnetic Interference
This equipment has been tested and found to comply with the EMC limits for the Medical Device
Directive 93/42/EEC (EN 55022 Class A and EN 60601-1-2). These limits are designed to provide
reasonable protection against harmful interference in a typical medical installation. The equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with these instructions, may cause harmful interference to other devices in the vicinity.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference with other devices, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving device
Increase the separation between the equipment
Connect the equipment into an outlet on a circuit different from that to which the other
device(s) is connected
Consult the manufacturer or field service technician for help
