9: Services Settings
EDS-MD User Guide
54
To View or Configure Syslog Settings:
Using Web Manager
To configure the Syslog, click
Syslog
in the menu.
Using the CLI
To enter the Syslog command level:
enable -> config -> syslog
Using XML
Include in your file:
<configgroup name=”syslog”>
HTTP Settings
Hypertext Transfer Protocol (HTTP) is the transport protocol for communicating hypertext
documents on the Internet. HTTP defines how messages are formatted and transmitted. It also
defines the actions web servers and browsers should take in response to different commands.
HTTP Authentication enables the requirement of usernames and passwords for access to the
device.
Table 9-4
HTTP Settings
Severity Log Level
Specify the minimum level of system message the EDS-MD should log. This
setting applies to all syslog facilities. The drop-down list in the Web Manager is
in descending order of severity (e.g., Emergency is more severe than Alert.)
HTTP Settings
Description
State
Select to enable or disable the HTTP server:
Enabled
(default)
Disabled
Port
Enter the port for the HTTP server to use. The default is
80
.
Secure Port
Enter the port for the HTTPS server to use. The default is
443
. The HTTP
server only listens on the
HTTPS
Port
when an SSL certificate is configured.
Secure Protocols
Select to enable or disable the following protocols:
SSL3
= Secure Sockets Layer version 3
TLS1.0
= Transport Layer Security version 1.0. TLS 1.0 is the successor of
SSL3 as defined by the IETF.
TLS1.1
= Transport Layer Security version 1.1
The protocols are enabled by default.
Note:
A server certificate and associated private key need to be installed in
the SSL configuration section to use HTTPS.
Secure Credentials
Specify the name of the set of RSA and/or DSA certificates and keys to be
used for the secure connection.
Syslog Settings
(continued)
Description
