5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference
562
character. Note that quotes must enclose the value
if it contains spaces.
aes encrypt key
<hexadecimal>
Sets the connect tunnel AES encrypt key with up to
16 bytes. Each byte is represented by two adjacent
hex digits. Bytes may run together or be separated
by optional punctuation: 123ABC "12 3A BC"
12,3A,BC 12.3a.bc 12:3a:bc Note that quotes must
enclose the value if it contains spaces.
aes encrypt key text
<text>
Sets the connect tunnel AES encrypt key with up to
16 bytes. Each byte is represented by a single
character. Note that quotes must enclose the value
if it contains spaces.
auto show statistics
show connection statistics
clrscrn
Clears the screen.
credentials
<text>
Selects the RSA/DSA certificates by name for the
SSL client.
default protocol
Restores the default protocol as "TCP".
default tcp keep alive idle time
Defaults the TCP keep alive idle time.
default tcp keep alive interval
Restores the default 45 second connect mode TCP
keep alive timeout.
default tcp keep alive probes
Defaults the TCP keep alive probes.
exit
Exits to the next higher level.
initial send binary
<binary>
Sets the host connect tunnel Initial Send text
allowing for binary characters. <binary> = string in
binary format that will be sent out the network upon
connection. Within [] use binary decimal up to 255
or hex up to 0xFF.
initial send set
<text>
Sets the host connect tunnel Initial Send text. <text>
= ascii string that will be sent out the network upon
connection.
no address
Removes the remote host address used to establish
tunneling connections.
no aes decrypt key
Removes the connect tunnel AES decrypt key.
no aes encrypt key
Removes the connect tunnel AES encrypt key.
no credentials
Clears the RSA/DSA certificate selection.
no initial send
Removes the host connect tunnel Initial Send string.
no port
Removes the remote port used to establish tunnel
connections.
no ssh username
Removes the SSH user name.
no tcp user timeout
Restores the default.
port
<number>
Sets the remote port to use for connect mode
tunneling. <number> = number of the port to use.
protocol ssh
Uses SSH protocol for connect mode tunneling.
protocol ssl
Uses SSL protocol for connect mode tunneling.
protocol tcp
Uses TCP protocol for connect mode tunneling.
protocol tcp aes
Uses TCP protocol with AES encryption for connect
mode tunneling.
protocol telnet
Uses Telnet protocol (with IAC) for connect mode
tunneling.
protocol udp
Uses UDP protocol for connect mode tunneling.
