13: Maintenance and Diagnostics Settings
EDS1100/2100 Device Server User Guide
111
IP Address Filter
The IP address filter specifies the hosts and subnets permitted to communicate with the EDS1100/
2100 device server. When the filter list is empty, then all IP addresses are allowed.
Note:
If using DHCP/BOOTP, ensure the DHCP/BOOTP server is in this list.
To configure the IP address filter:
1. Select
IP Address Filter
on the menu bar. The IP Address Filter page opens to display the
current configuration.
Figure 13-14 IP Address Filter Configuration
Note:
If you enter any filter, be careful to make sure that your network IP address is
covered. Otherwise you will loose access to the EDS1100/2100 unit. You will have to then
access the EDS1100/2100 device server from a different computer to reset the
configuration.
2. Enter or modify the following settings:
Table 13-15 IP Address Filter Settings
3. Click
Add.
Note:
In the Current State table, click
Remove
to delete any existing settings, as
necessary.
IP Address Filter
Settings
Description
IP Address
Enter the IP address to add to the IP filter table.
Network Mask
Enter the IP address’ network mask in dotted notation.
