8: Line and Tunnel Settings
EDS1100/2100 Device Server User Guide
46
4. Enter or modify the following settings:
Table 8-3 Line Configuration
5. Click
Submit.
6. Repeat above steps as desired, according to additional line(s) available on your product.
Line - Configuration
Settings
Description
Name
If the Terminal Login Menu feature is being used, enter the name for the line.
Leaving this field blank will disable this line from appearing in the Terminal Login
Menu. The default Name is blank. See
Terminal and Host Settings on page 66
for related configuration information.
Interface
Select the interface type from the drop-down menu. The default is RS232.
Note:
This option is only supported in XPort Pro, EDS4100, EDS1100 and
EDS2100 device servers.
State
Indicates whether the current line is enabled. To change the status, select
Enabled or Disabled from the drop-down menu.
Protocol
Select the protocol from the drop-down menu. The default is Tunnel.
Note:
All protocols work in Connect and Accept Mode except the LPD or Tunnel
protocol option which is supported only in Accept Mode.
Baud Rate
Select the baud rate from the drop-down menu. The default is 9600.
Parity
Select the parity from the drop-down menu. The default is None.
Data Bits
Select the number of data bits from the drop-down menu. The default is 8.
Stop Bits
Select the number of stop bits from the drop-down menu. The default is 1.
Flow Control
Select the flow control from the drop-down menu. The default is None.
Xon Char
Specify the character to use to start the flow of data when Flow Control is set to
Software. Prefix a decimal character with \ or a hexadecimal character with 0x, or
provide a single printable character. The default Xon char is 0x11.
Xoff Char
Specify the character to use to stop the flow of data when Flow Control is set to
Software. Prefix a decimal character with \ or a hexadecimal character with 0x, or
provide a single printable character. The default Xoff char is 0x13.
Gap Timer
The driver forwards received serial bytes after the
Gap Timer
delay from the last
character received. By default, the delay is four character periods at the current
baud rate (minimum 1 ms).
Threshold
The driver will also forward received characters after
Threshold
bytes have
been received.
Buffer
Enter the buffer in Kbytes. Specifies the buffer size allocation in RAM that will be
used in Tunnel Accept and Tunnel Connect mode connection/session. Buffer
range is 16 to 1200 Kbytes.
