14: Advanced Settings
EDS1100/2100 Device Server User Guide
128
2. Enter or modify the following settings:
Table 14-5 CLI Configuration
3. Click
Submit
.
Command Line Interface
Configuration Settings
Description
Login Password
Enter the password for Telnet access.
Enable Level Password
Enter the password for access to the Command Mode Enable level. There is
no password by default.
Quit Connect Line
Enter a string to terminate a connect line session and resume the CLI. Type
<control>
before any key the user must press when holding down the
Ctrl
key. An example of such a string is
<control>L.
Inactivity Timeout
Set an Inactivity Timeout value so the CLI session will disconnect if no data is
received after the designated time period. Default is 15 minutes. Enter a value
of 0 to disable.
Login String State
Select to enable or disable. The login string state controls the display of a
device-specific string when SSH or Telnet connection is established to the CLI.
Login String
Enabling the login string state allows the display of the Login string. The login
string cannot exceed 32 characters. By default Login String will be the device
name.
Note:
This configuration field appears when Login String State is enabled
above. This Login String setting only applies to SSH or Telnet connections to
the CLI. If the serial line is being used in Command Mode, for CLI access, then
refer to the
section for those applicable settings.
Telnet State
Select
Disabled
to disable Telnet access. Telnet is enabled by default.
Telnet Port
Enter the Telnet port to use for Telnet access. The default is
23
.
Telnet Max Sessions
Maximum number of simultaneous Telnet sessions. The default is 3 and the
maximum is 10.
SSH State
Select
Disabled
to disable SSH access. SSH is enabled by default.
SSH Port
Enter the SSH port to use for SSH access. The default is
22
.
SSH Max Sessions
Maximum number of simultaneous SSH sessions. The default is 3 and the
maximum is 10.
