6: Configuration Using Web Manager
EDS1100/2100 Device Server User Guide
38
In the middle of many pages, you can select or enter new configuration settings. Some pages
show status or statistics in this area rather than allow you to enter settings.
At the bottom of most pages, the current configuration is displayed. In some cases, you can
reset or clear a setting.
The information or help area shows information or instructions associated with the page.
A
Logout
button is available at the upper right corner of every web page. In Chrome or Safari,
it is necessary to close out of the browser to logout. If necessary, reopen the browser to log
back in.
The footer appears at the very bottom of the page. It contains copyright information and a link
to the Lantronix home page.
Navigating the Web Manager
The Web Manager provides an intuitive point-and-click interface. A menu bar on the left side of
each page provides links you can click to navigate from one page to another. Some pages are
read-only, while others let you change configuration settings.
Note:
There may be times when you must reboot the EDS1100/2100 for the new
configuration settings to take effect. The chapters that follow indicate when a change
requires a reboot.
Table 6-4 Summary of Web Manager Pages
Web Manager Page
Description
See
Page
Status
Shows product information and network, line, and tunneling settings.
CLI
Shows Command Line Interface (CLI) statistics and lets you change the
current CLI configuration settings.
Diagnostics
Lets you perform various diagnostic procedures.
DNS
Shows the current configuration of the DNS subsystem and the DNS
cache.
Shows email statistics and lets you clear the email log, configure email
settings, and send an email.
Filesystem
Shows file system statistics and lets you browse the file system to view a
file, create a file or directory, upload files using HTTP, copy a file, move a
file, or perform TFTP actions.
FTP
Shows statistics and lets you change the current configuration for the
File Transfer Protocol (FTP) server.
Host
Lets you view and change settings for a host on the network.
HTTP
Shows HyperText Transfer Protocol (HTTP) statistics and lets you
change the current configuration and authentication settings.
IP Address Filter
Lets you specify all the IP addresses and subnets that are allowed to
send data to this device.
Line
Shows statistics and lets you change the current configuration and
Command mode settings of a serial line.
