9: Terminal and Host Settings
EDS1100/2100 Device Server User Guide
68
Table 9-4 Terminal on Line 1 Configuration
4. Click
Submit
to save changes.
5. Repeat above steps as desired, according to the additional line(s) available on your product.
Host Configuration
This Host web page is where you may view and modify current settings for a selected remote host.
To configure a selected remote host:
1. Select
Host
on the menu bar. The Host web page appears.
2. Select a specific host number at the top of the page. The Host Configuration page for the
selected host appears.
Note:
Number of hosts available differ among Lantronix products. Hosts available for
selection may appear listed on the screen (see
) or within a drop-down menu
above the Configuration button.
Terminal on Line
Configuration Settings
Description
Terminal Type
Enter text to describe the type of terminal. The text will be sent to a host via IAC.
Note:
IAC means, “interpret as command.” It is a way to send commands over
the network such as
send break
or
start echoing
.
Login Connect Menu
Select the interface to display when the user logs in. Choices are:
Enabled
= shows the Login Connect Menu.
Disabled
= shows the CLI
Exit Connect Menu
Select whether to display a choice for the user to exit the Login Connect Menu
and reach the CLI. Choices are:
Enabled
= a choice allows the user to exit to the CLI.
Disabled
= there is no exit to the CLI.
Send Break
Enter the
Send Break
control character. If this specified character is received by
the serial line, it will not be sent to the line; instead the line output will be forced
inactive. Sample setting:
<Control>Y
. Blank the field to set to <None>.
Break Duration
Enter the time in milliseconds for how long the spacing condition will be placed
on the line when a break is sent.
Echo
Applies only to Connect Mode Telnet connections, not to Accept Mode. Only
disable
Echo
if your terminal echoes, in which case you will see double of each
character typed.
