7: Networking
EMG™ Edge Management Gateway User Guide
101
2. Enter the following information:
3. To save, select
Apply
.
To configure the wireless client:
1. Enter the following information:
2. To save, select
Apply
.
Wireless Mode
Select the mode that WiFi should operate in.
Wireless Client:
If selected, enables the EMG to act as a wireless
client of a WLAN network. In order to connect to a WLAN network, a
WLAN profile for that network needs to exist and be enabled. The
default is for the wireless client to be disabled
Wireless Access Point:
If selected, enables the access point to
scan for wireless clients and allow them to connect and
authenticate to the EMG. The default is for the access point to
be enabled. The access point cannot be enabled if the wireless
client is enabled.
Disabled:
If selected, disables the wireless client and the access point.
WLAN Settings
Select how an IP address is assigned to the wireless client: if Obtain
from DHCP is selected, the EMG will acquire an IP address and subnet
mask from the access point it connects to. If Specify is selected, the
user can enter an IP address and subnet mask that is on the same
subnet as the access point.
DHCP Acquired Gateway
(read only) Displays any gateway acquired from the access point the
wireless client connects to. This gateway can be set as the default
gateway for the EMG by configure the gateway precedence in the
DHCP Acquired Primary/
Secondary DNS
(read only) Displays any DNS servers acquired from the access point
the wireless client connects to.
IPv6 Address (Static)
Enter the IPv6 address for the wireless client. This requires that IPv6
be enabled in the Network Port Settings.
IPv6 Address (Link Local)
(read only) Displays the link local IPv6 address for the wireless client.
This requires that IPv6 be enabled in the Network Port Settings.
MTU
Specifies the Maximum Transmission Unit (or Maximum Packet Size)
of packets at the IP layer (OSI layer 3) for the wireless client. When
fragmenting a datagram, this is the largest number of bytes that can be
used in a packet. The minimum MTU size is 108 bytes (to conform with
RFC 2460) and the maximum size is 1500 bytes.
HW Address
(read only) Displays the MAC address of the wireless client.
Link State
(read only) Displays the link status (up and running, or down) of the
wireless client interface.
Connection Status
(read only) Displays the status of the wireless client - connected to a
WLAN network, or disconnected.
Connected/Disconnected at
(read only) displays the time at which the wireless connected or
disconnected from the WLAN network.
WLAN Network Information
(read only) If the wireless client is connected to a WLAN network the
BSSID, SSID, Frequency Band, Signal, Pairwise Cipher, Group Cipher
and Key Management for the WLAN network are displayed.
Summary of Contents for EMG 7500
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings ...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG ...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity ...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued ...
