EMG™ Edge Management Gateway User Guide
409
Appendix C: Adapters and Pinouts
The serial device ports of the EMG products match the RJ45 pinouts of the console ports of many
popular devices found in a network environment. The EMG uses conventional straight-through
Category 5 fully pinned network cables for all connections when used with Lantronix adapters. The
cables are available in various lengths.
In most cases, you will need an adapter for your serial devices. Lantronix offers a variety of RJ45-
to-serial connector adapters for many devices. These adapters convert the RJ45 connection on
the EMG unit to a 9-pin or 25-pin serial connector found on other manufacturers' serial devices or
re-route the serial signals for connections to other devices that use RJ45 serial connectors.
The console port is wired the same way as the device ports and has the same signal options.
Note:
You can view or change the console port settings using the
the command line interface
show console port
and
set consoleport
commands.
The adapters illustrated below are compatible with the Lantronix EMG models.
Figure C-1 RJ45 Receptacle to DB25M DCE Adapter for the EMG Unit (PN 200.2066A)
Use PN 200.2066A adapter with a dumb terminal or with many SUN applications.