8: Services
EMG™ Edge Management Gateway User Guide
159
Figure 8-5 IP Address Login Page
To directly access the CLI interface for a device:
1. Make sure that Web Telnet or Web SSH is enabled for the specific device.
2. On the Secure Lantronix Network page, click the
SSH
or
Telnet
link in the SSH/Telnet to CLI
column directly beside the device you would like to access.
3. Click your mouse into the CLI login interface that appears and login. The CLI interface will
indicate when your connection is established.
4. To terminate the session, use either the host's logoff command or use
^]
to terminate a
Telnet session or
~.
to terminate an SSH session.
Figure 8-6 SSH or Telnet CLI Session
To directly access a specific port on a particular device:
1. You have two options:
-
Dashboard
Make sure the
WebSSH (DP only)
radio button directly beneath the Dashboard is
selected and click the desired port number. The Dashboard is located on the upper right
corner of each Web Manager page (see
.) The CLI login interface appears.
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
