6: Web and Command Line Interfaces
EMG™ Edge Management Gateway User Guide
76
2. Enter your EMG password and press
Enter
.
Logging Out
To log out of the EMG command line interface, type
logout
and press
Enter
.
Command Syntax
Commands have the following format:
<action> <category> <parameter(s)>
where
<action>
is
set
,
show
,
connect
,
admin
,
diag
, or
logout
.
<category>
is a group of related parameters whose settings you want to configure or view.
Examples are ntp, deviceport, and network.
<parameter(s)>
is one or more name-value pairs in one of the following formats:
Command Line Help
For general Help and to display the commands to which you have rights, type:
help
For general command line Help, type:
help command line
For release notes for the current firmware release, type:
help release
For more information about a specific command, type help followed by the command. For
example:
help set network or help admin firmware
Tips
Type enough characters to identify the action, category, or parameter name uniquely. For
parameter values, type the entire value. For example, you can shorten:
set network port 1 state static ipaddr 122.3.10.1 mask 255.255.0.0
to
se net po 1 st static ip 122.3.10.1 ma 255.255.0.0
Use the Tab key to automatically complete action, category, or parameter names. Type a
partial name and press
Tab
either to complete the name if only one is possible, or to display
the possible names if more than one is possible. Following a space after the preceding name,
Tab displays all possible names.
Should you make a mistake while typing, backspace by pressing the Backspace key and/or
the Delete key, depending on how you accessed the interface. Both keys work if you use
VT100 emulation in your terminal access program when connecting to the console port. Use
the left and right arrow keys to move within a command.
<parameter name> <aa|bb>
User must specify one of the values (
aa
or
bb
) separated by a
vertical line (
|
). The values are in all lowercase and must be
entered exactly as shown. Bold indicates a default value.
<parameter name> <Value>
User must specify an appropriate value, for example, an IP address.
The parameter values are in mixed case. Square brackets
[ ]
indicate optional parameters.
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
