EMG™ Edge Management Gateway User Guide
232
11: Remote Power Managers
The EMG supports managing remote power managers (RPMs) for devices from over 140 vendors.
The RPM can be either a power distribution unit (PDU) or uninterruptible power source/supply
(UPS), and can be managed via SNMP, serial port, network and USB connections. The RPMs
web page displays a list of all currently managed RPMs with an overview of their current status,
with options to control and view detailed status for each RPM, depending on its supported
capabilities.
For notes on optimizing the management of specific devices, see
Optimizing and Troubleshooting RPM Behavior (on page 244)
Devices - RPMs
To control or view status for an RPM:
1. Click the
Devices
tab and select the
RPMs
option. The RPMs page displays.
Figure 11-1 Devices > RPMs
2. In the RPMs table, select the RPM by clicking on the radio button in the far right column.
The options that are available for that RPM will be displayed as active links above the RPMs
table.
3. Select one of the following options:
Refresh
Refreshes the information in the RPMs table.
Add Device
Displays the
page to add a new
managed PDU or UPS.
Shutdown Order
Displays the order in which all UPS devices are shutdown in the event
that a UPS reaches a low battery state. See
. For more
information, see
.
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
