14: User Authentication
EMG™ Edge Management Gateway User Guide
290
Local and Remote User Settings
The system administrator can configure the EMG to use local accounts and remote accounts to
authenticate users.
1. Click the
User Authentication
tab and select the
Local/Remote Users
option. The following
page displays.
Figure 14-3 User Authentication > Local/Remote Users
The top of the page has entry fields for enabling local and remote users and for setting
password requirements. The bottom of the page displays a table listing and describing all local
and remote users.
To enable local and/or remote users:
1) Enter the following:
Enable Local Users
Select to enable all local users except sysadmin. The sysadmin user is always
available regardless of how you set the check box. Enabled by default.
Multiple Sysadmin
Web Logins
Select to allow the sysadmin to have multiple simultaneous logins to the web
interface. Disabled by default.
Sysadmin Access
Limited to Console
Port
Select to limit sysadmin logins to the physical EMG console port only. Disabled
by default.
Note:
For security purposes, full administrative access to the EMG via the
default sysadmin local user account can be limited to only the front console port
Limiting Sysadmin User Access on page 71
.
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
