EMG™ Edge Management Gateway User Guide
358
16: Application Examples
Each EMG has multiple serial ports and two network ports. Each serial port can be connected to
the console port of an IT device. Using a network port (in-band) or a modem (out-of-band) for dial-
up connection, an administrator can remotely access any of the connected IT devices using Telnet
or SSH.
Figure 16-1 EMG - Configuration
This chapter includes three typical scenarios for using the EMG unit. The scenarios assume that
the EMG is connected to the network and has already been assigned an IP address. In the
examples, we use the command line interface. You can do the same things using the web page
interface except for directly interacting with the EMG unit (
direct
command).
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
