3: EMG 8500 Installation
EMG™ Edge Management Gateway User Guide
42
Wall Mount Installation
shows the wall mount and keyhole mount configuration.
Figure 3-5 EMG 8500 Wall Mount Dimensions
Wall Mount and Keyhole Mount Instructions
Walls Requiring Anchors
These instructions are for mounting the EMG to walls made of solid concrete, block, brick, or
plasterboard.
(1) Wall mount:
1. Locate the place where you want to mount the unit and mark four holes using your EMG
mount as a guide for the screws. See for the location of the screw holes.
2. Drill four 3/16 inch (4.8 mm) diameter holes at a depth of 1.25 inches (32 mm).
3. Insert the anchors until they are flush with the surface.
4. Thread four pan head top mount screws through the unit mount hole and through the anchor,
and tighten them.
(2) Keyhole mount:
1. Locate the place where you want to mount the unit and mark two holes using your EMG mount
as a guide for the screws. See for the location of the screw holes.
2. Drill two 3/16 inch (4.8 mm) diameter holes at a depth of 1.25 inches (32 mm).
3. Insert the anchors until they are flush with the surface.
4. Thread two pan head top mount screws through the unit mount hole and through the anchor,
and reserve 0.08” to 0.12” (2-3 mm) clearance to the anchor surface.
5. Hang the EMG unit where both keyholes of wall mounts can go through the screw heads on
the wall.
(2) Keyhole
mount
(1) Wall
mount
(1)
(1)
(1)
(2)
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
