3: EMG 8500 Installation
EMG™ Edge Management Gateway User Guide
50
6. Tighten the screw on the module with your fingers. Be careful not to over tighten it.
7. To verify the new module is recognized, connect power to the EMG, wait for it to boot, and log
into the web manager. The new module will be displayed in the Dashboard.
Connectivity Module Installation
The EMG module port configuration can be changed by adding or replacing connectivity modules
in the connectivity module bays.
Warning:
The EMG must be powered off when installing or replacing the modules.
Not powering off the device before changing the module will void the
manufacturer warranty.
Warning:
Install the connectivity module on the back only of the EMG unit. Do not
insert any other module on the back of the EMG unit. Doing so may
damage the EMG unit and will void the manufacturer warranty.
To install the connectivity module:
1. Disconnect the power cord from the EMG unit and from the wall outlet.
2. On the back of the EMG unit, locate the module bay where the module will be inserted.
3. Unscrew the existing module or faceplate from the module bay with your fingers and carefully
remove it from the module bay.
4. Insert the module into the module bay making sure the module sits completely and securely in
the housing.
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
