7: Networking
EMG™ Edge Management Gateway User Guide
83
Figure 7-3 Network Settings > SFP NIC Information & Diagnostics
2. Enter the following information:
Ethernet Interfaces (Eth1 and Eth2)
Note:
Configurations with the same IP subnet on multiple interfaces (Ethernet or PPP)
are not currently supported.
Eth1 Settings
or
Eth2 Settings
Disabled:
If selected, disables the network port.
Obtain from DHCP:
Acquires IP address, subnet mask, hostname and gateway
from the DHCP server. (The DHCP server may not provide the hostname
gateway, depending on its setup.) This is the default setting. If you select this
option, skip to Gateway.
Obtain from BOOTP:
Lets a network node request configuration information
from a BOOTP "server" node. If you select this option, skip to Gateway.
Specify:
Lets you manually assign a static IP address, generally provided by the
system administrator.
IP Address
(if specifying)
Enter an IP address that will be unique and valid on your network. There is no
default.
Enter all IP addresses in dot-quad notation. Do not use leading zeros in the
fields for dot-quad numbers less than 100. For example, if your IP address is
172.19.201.28, do not enter 028 for the last segment octet.
Note:
Currently, the EMG unit does not support configurations with the same IP
subnet on multiple interfaces (Ethernet or PPP).
Subnet Mask
If specifying an IP address, enter the network segment on which the EMG unit
resides. There is no default.
Summary of Contents for EMG Series
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued...
