Lantronix
ION002-AD User Guide
33612 Rev B
8
Notes
: It is a good practice to turn OFF input and load power, and unplug the power Terminal Block before
making wire connections. Otherwise, a metal screwdriver blade can inadvertently short the terminal connections
to the grounded enclosure. However, in some instances this is not possible as this may be a bussed power rail
providing power to numerous other devices. Also note:
•
The range of suitable wire for the terminal block is 12 to 26 AWG.
•
The power source must be safety certified.
Connecting Power Wires to the Terminal Block
1. Strip the wires to the proper length.
2. Insert the positive and negative power wires into V+ and V- contacts respectively of the Terminal Block (note p
olarity on the ION002-AD chassis). Make sure the wires are secure. See figure below.
3. Insert the positive and negative power wires into V+ and V- contacts respectively into the power source—mak
e sure the wires are secure. See the figures above. Insert the positive and negative power wires into V+ and
V- contacts respectively into the power source—make sure the wires are secure. See the figure below.
Reinstalling the Terminal Block and verifying power wire connections
4. Reinstall the Terminal Block into the primary location on the ION002-AD.
5. Tighten the two screws to secure the Terminal Block to the ION002-AD chassis.
6. Turn the power source ON and observe that the green front panel PWR (power) LED is lit, indicating that pow
er is applied to the ION002-AD. See the figure below.
Terminal Block
Power Wires
Wire Securing
Screws
Chassis Mounting
Screws Qty (2)
Wire Slots
Connect to AC/DC
power source
