5: Installation
E210 Series Cellular Router User Guide
21
5.6.6 Default Configuration
All usernames and passwords are case sensitive.
5.6.6.1 Default Configuration for Web Admin Page
If the installed ePack firmware is version 2.4.4 and higher, the default factory passwords are:
User
Default Password
admin
admin
root
L@ntr0n1x
Table 5-3: Default Web Admin Page Credentials
Note:
•
ePack firmware versions 2.4.4 and above require you to change the factory default
passwords before any other router configuration can be done. Both the admin and
root passwords must be changed.
If the installed ePack firmware is older than version 2.4.4, the default factory passwords are:
User
Default Password
admin
admin
root
M@estroW1rele$$
Table 5-4: Default Web Admin Page Credentials
Note: Username and password are both case sensitive.
5.6.6.2 Wireless Access Point SSID
The wireless access point SSID may be configured in the Web Admin console.
Parameter
Details
SSID
Lantronix E21X - for E210 series devices
Lantronix E22X - for E220 series devices
WPA/WPA2 TKIP Key
W1rele$$
Table 5-5: Default Wi-Fi Credentials
5.6.6.3 Default Interface Configuration
Interface
Details
WAN (Ethernet)
Automatic (DHCP client)
Priority source of Internet with Cellular backup
LAN (Ethernet)
Active DHCP with starting IP address
192.168.1.100 with pool of 100 clients.
Cellular
No PAP/CHAP authentication
Wireless (LAN)
Wi-Fi enabled as access point with SSID
"Lantronix E21X" or "Lantronix E22X"
Table 5-6: Default Interface Configuration
