F-1
F
F
:
:
F
F
r
r
e
e
q
q
u
u
e
e
n
n
t
t
l
l
y
y
U
U
s
s
e
e
d
d
C
C
o
o
m
m
m
m
a
a
n
n
d
d
s
s
This appendix lists some of the most frequently used commands of
the
Print Server
command set. More information about the
command set, including additional options, can be found in the
Server Reference Manual
located on the CD-ROM.
Conventions
Please note the following before continuing:
Commands are divided into Server (general), Port, and
Protocol sections. Within each section, commands are
listed alphabetically.
Commands may require privileged user status. Enter
Set
Privileged
, then enter the privileged password when
prompted.
When you enter a
Define
(or
Purge
) command, you
must reboot the MPS for the command to take effect.
Alternately, you can issue several
Set
commands and
then a
Save
command to make the
Set
commands take
effect without rebooting.
When the abbreviated syntax “{
EN/DIS
}” is shown, you
must choose either
Enabled
or
Disabled
to complete
the command.
Server Commands
Table 17: Frequently used Server Commands
Command
Option(s)
Description
DEFINE SERVER BOOTP {EN/DIS}
Enables or disables querying
for a BOOTP host at system
boot time.
DEFINE SERVER DHCP {EN/DIS}
Enables or disables querying
for a DHCP host at system
boot time.
DEFINE SERVER GATEWAY ipaddr
Specifies the host to be used
as a TCP/IP gate way to
forward packets between
networks. Enter an IP
address.
Summary of Contents for MPS100
