Lantronix
OCA-P181610 Install Guide
33812 Rev. D
Page
6
of
17
Regulatory Agency Compliance
Base Cabinet Compliance
Standard(s) for Safety: Standard for Enclosures for Electrical Equipment, UL 50
UL 50E ENCLOSURES FOR ELECTRICAL EQUIPMENT
CSA C22.2 NO. 94.1.07 ENCLOSURES FOR ELECTRICAL EQUIPMENT, NON-ENVIRONMENTAL
CONSIDERATIONS
CSA C22.2 NO. 94.2-07 ENCLOSURES FOR ELECTRICAL EQUIPMENT, ENVIRONMENTAL
CONSIDERATIONS
RoHS, WEEE, Environmental Programs
: See
https://www.transition.com/rohs-weee-environmental-programs/
Components
Check the package contents to make sure you have received the following items. Contact your sales
representative if any item is damaged or missing. Please save the packaging for possible future use.
•
One 18x16x10” NEMA 4X/IP66 polycarbonate cabinet
•
Two DIN Rails (installed)
•
Two Ground Terminal Blocks for 12-26 AWG wire, 8kV rated surge protection (installed)
•
One each Red and Black Terminal Blocks for 12-26 AWG wire, 8kV rated surge protection for DC +/-
Wires (installed)
•
One each Blue and White Terminal Blocks for 12-26 AWG wire, 8kV rated surge protection for AC Mains
Line and Neutral/Line Connections (installed)
•
One Power Wire Gland (installed)
*
•
Ten Data Wire Glands (accommodate 2 Cables each) (installed)
*
•
One 22365 Magnetic Door Contact Switch (installed)
•
Nine 22339 Hole Plugs
*
•
Nine 22338 Hole Plugs
*
•
Six Terminal Block 22381 End Caps (3 installed, 3 extras provided to be inserted for safety if terminal
blocks are separated from initial configuration)
*
Note
:
Not filling unused wire glands with hole plugs provided or improper tightening of nuts can affect NEMA/IP
rating and void cabinet warranty. After installing cabling, ensure all nuts are properly tightened:
•
Power Wire Gland (x1): Using Torque Wrench, tighten nut to 75-80 in. lbs.
•
Data Wire Glands (x10): Using Torque Wrench, tighten nuts to 75-80 in. lbs.
