6. Teseo-Suite Connection
PNT-SG3FS Evaluation Kit User Guide
15
6.
Teseo-Suite Connection
Install and start Teseo-Suite (
https://www.st.com/en/embedded-software/teseo-suite.html
), and
follow the directions in the following sections.
23B
Getting Started with Teseo-Suite
When the Teseo-Suite application starts, Teseo-Suite opens the Configuration Session panel as
shown in Figure 11 below.
Enter a session name to enable the “Add Device” button.
Figure 10. Configuration Session Panel
If the Configuration Session panel does not appear, either open the File menu and select "New
Session" or click the “Edit Session Configuration” button shown in Figure 12.
Figure 11. Edit Session Configuration Button
24B
Add/Delete Device
In the Configuration Session panel, you can add/delete PNT-SG3FS-EVAL devices in the work
session and monitor existing devices.
Click the "Add Device" button to bring up the Configuration Device form shown in Figure 14.
Configure the following fields as described:
Hardware type: STA8090
Control Port Protocol: NMEA
The following Control Port fields should use the same parameters of the serial connection
as defined in Table 1: Baud Rate – 9600; Data Bits – 8; Parity – None; Stop Bits – One
Click Ok to add the device.
