5: Network Settings
PremierWave® 2050 802.11ac Embedded Wi-Fi® User Guide
31
IP Address
Enter the static IPv4 address to use for the interface. You may enter it alone or in
CIDR format.
Note:
This setting will be used if Static IP is active (both DHCP and BOOTP are
Disabled). Changing this value requires you to reboot the device. When DHCP or
BOOTP is enabled, the PremierWave 2050 gateway tries to obtain an IPv4
address from a DHCP or BOOTP server. If it cannot, the PremierWave 2050
gateway generates and uses an Auto IP address in the range of 169.254.xxx.xxx,
with a network mask of 255.255.0.0.
Default Gateway
Enter the IPv4 address of the router for this network.
Note:
This setting will be used if Static IP is active (both DHCP and BOOTP are
Disabled
).
Domain
Enter the domain name suffix for the interface.
Note:
This setting will be used when either static IP or auto IP is active, or if
DHCP/BOOTP is active and no domain suffix was acquired from the server
.
DHCP Client ID
Enter the ID if the DHCP server requires a DHCP client ID option. The DHCP
server’s lease table shows IP addresses and MAC addresses for devices. The
lease table shows the client ID, in hexadecimal notation, instead of the
PremierWave 2050 gateway MAC address.
Primary DNS
Enter the IP address of the primary domain name server (DNS.)
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
Secondary DNS
Enter the IP address of the secondary domain name server.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
IPv6 State
Select to enable or disable.
IPv6 DHCP Client
S
elect to turn
On
or
Off
. At bootup, after the physical link is up, the PremierWave
2050 gateway will attempt to obtain IPv6 settings from a DHCPv6 server and will
periodically renew these settings with the server.
On:
enables the PremierWave 2050 server to obtain IPv6 setting from a
DHCPv6 server upon bootup.
Off:
enables the PremierWave 2050 server to obtain IPv4 settings from a DHCP
server upon bootup.
Note:
Overrides the configured IP address/mask, gateway, hostname, and
domain. Changing this value requires you to reboot the device. Within Web
Manager, click Renew to renew the DHCPV6 lease.
IPv6 IP Address
Enter the static IPv6 address to use for the interface.
Note:
This setting is used if Static IPv6 is active (DHCPv6 is Disabled). Changing
this value requires a reboot. When DHCPv6 is enabled, the PremierWave 2050
gateway tries to obtain an IPv6 address from a DHCPv6 server. If it cannot, then
PremierWave 2050 gateway generates and uses a Link local IPv6 address.
IPv6 Default Gateway
Enter the default IPv6 default gateway.
IPv6 Domain
Enter the domain name suffix for the interface.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no Domain Suffix was acquired from the server.
IPv6 Primary DNS
Enter the IP address of the primary domain name server.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
Field/Button
Description
