6: Network Settings
PremierWave® Intelligent Gateway User Guide
47
To Configure Network 2 QoS Settings
Using Web Manager
To modify Ethernet (eth0) QoS information, click
Network
on the menu and select
Network 2
> QoS > Configuration
.
Using the CLI
To enter the eth0 QoS command level:
enable -> config -> if 2 -> qos
Using XML
Include in your file:
<configgroup name="cellular" instance="wwan0">
Gateway
The PremierWave XNXC HSPA+ intelligent gateway can be configured as a cellularwireless router
with DHCP server functionality.
Status
This page displays the current configuration and statistics information for the gateway.
To view gateway status: click
Gateway
on the menu and select
Status
.
WAN
Table 6-10 WAN Configuration
Gateway Settings
Description
Operating Mode
Select the type of operating mode:
Disabled
: prevents the device to be used as a gateway; use the device
normally.
Gateway
: allows the device to be used as a router with NAT.
Router
: allows the device to be used as a router without NAT.
Firewall
Select to enable or disable firewall:
Enabled
: enables the device firewall.
Disabled
: disable the device firewall.
MAC Address filter
Select to enable or disable the MAC address filter.
Interface
Specify the WAN interface. Generally wwan0 (cellular) interface.
IP Address
Assign a static IP address to the gateway.
IPv6 Address
Assign a static IPv6 address to the gateway.
Primary DNS
Enter the IP address of the primary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or
if DHCP/BOOTP is active and no DNS server was acquired from the
server.
