6: Network Settings
PremierWave® XN Intelligent Gateway User Guide
48
To Configure Network 2 QoS Settings
Using Web Manager
To modify Ethernet (eth0) QoS information, click
Network
on the menu and select
Network 2
> QoS > Configuration
.
Using the CLI
To enter the eth0 QoS command level:
enable -> config -> if 2 -> qos
Using XML
Include in your file:
<configgroup name="qos" instance="wlan0">
WLAN Link Status and Scan Commands
These commands display information about the current state of the wireless network.
Table 6-9 Network 2 Link Scan
The results of the
scan
command are presented in the following format in the table below:
MAC Address
Enter the MAC address, if the MAC Address filter type is selected.
Network
Enter the Network, if the Network filter type is selected.
Ports
Enter the Port, if the Port filter type is selected.
Priority
Select the priority of the filter from the drop-down menu.
WLAN Link Information
Commands
Description
Network Name
Enter the Service Set Identifier (network name) of the device, if known. If the
field is kept empty, the scan performed will search for all available wireless
devices.
Scan “<network SSID>”
Perform a scan for devices within range of the device server. Including the
optional network SSID limits the scan to devices configured with the specified
network SSID. Omitting the network SSID performs a scan for all devices in
range.
Note:
When omitting the network SSID it is still necessary to include the
opening and closing quotation marks (scan “”). When the PremierWave unit is
associated with an access point, scanning is only preformed on the band on
which the unit is connected.
Refresh scan results
every 60 seconds
(checkbox)
Check this to auto update the list of networks every 60 seconds.
Uncheck this to stop auto update.
Adding or Deleting
Network 2 (QoS) Settings
Description
