6: Network Settings
PremierWave® XN Intelligent Gateway User Guide
62
WAN MAC Address Filters
Accept or drop traffic from specified MAC addresses using the settings below.
Table 6-21 Adding a New MAC Address Filters
To Configure Gateway WAN Settings
Using Web Manager
To modify gateway WAN information, click
Gateway
on the menu and select
Configuration >
WAN
.
Using the CLI
To enter the gateway command level:
enable -> config -> gateway
Using XML
Include in your file:
<configgroup name="gateway"> <configitem name="wan">
Port Forwarding
Port forwarding allows remote computers (for example, computers on the Internet) to connect to a
specific computer or service within a private local-area network (LAN). Port Forwarding rules
apply to inbound traffic and will not work if the device is not reachable or traffic to certain ports is
blocked before it reaches the device.
If traffic is going through firewalls, all referenced ports on the gateway and LAN devices must be
accessible.
Table 6-22 Port Forwarding Rules List
Adding or Deleting New MAC
Address Filter Settings
Description
Delete
Click the checkbox to the left of any existing mac address filter to be
deleted and click the
Submit
button.
MAC Address
Enter a new mac address to add a new filter.
Action
Select to
ACCEPT
or
DROP
above indicated MAC Address field.
Port Forwarding Rule
Description
Enabled
Enables the port forwarding rule.
Delete
Deletes the port forwarding rule.
Name
User friendly name for the rule. Click on the [Edit] icon to make changes.
Ingress IP Address: Port
Range
Port or Port range for the rule.
Protocol
Protocols for the rule: TCP, UDP, or Both.
IP Address: Target Port
Target for the port forwarding rule.
