Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
219
of
272
Command
:
ip
Description
:
Configure Internet Protocol for an interface.
Syntax
:
ip
arp inspection check-vlan
ip
arp inspection logging { deny | permit | all }
ip
arp inspection trust
ip
dhcp snooping trust
ip
igmp snooping filter <profile_name>
ip
igmp snooping immediate-leave
ip
igmp snooping max-groups <throttling>
ip
igmp snooping mrouter
ip
verify source
ip
verify source limit <cnt_var>
Parameters
: arp
Address Resolution Protocol
dhcp Dynamic Host Configuration Protocol
igmp Internet Group Management Protocol
verify
verify command
inspection ARP inspection
check-vlan ARP inspection VLAN mode configuration
logging ARP inspection logging mode configuration
trust ARP inspection trust configuration
snooping Snooping IGMP
filter Access control on IGMP multicast group registration
immediate-leave Immediate leave configuration
max-groups IGMP group throttling configuration
mrouter Multicast router port configuration
limit
limit command
<0-2>
the number of limit
all
log all entries
deny log denied entries
permit
log permitted entries
<word16> Profile name in 16 char's – filter
<1-10>
Maximum number of IGMP group registration
source
verify source
snooping DHCP snooping
trust
DHCP Snooping trust configuration
<cr>
Example
:
SISPM1040-582-LRT(config-if)#
ip arp inspection trust
SISPM1040-582-LRT(config-if)#
ip arp inspection check-vlan
SISPM1040-582-LRT(config-if)#
ip igmp snooping mrouter
SISPM1040-582-LRT(config-if)#
ip verify source limit 1
SISPM1040-582-LRT(config-if)#
ip dhcp snooping trust
SISPM1040-582-LRT(config-if)#
