Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
68
of
272
Command
:
mrp
Description
:
Create 1-2 new Media Redundancy Protocol instances, set parameters, and delete instances.
MRP is a data network protocol standardized by the International Electrotechnical Commission as
IEC 62439-2. MRP allows Ethernet switch rings to overcome any single failure with recovery time
much faster than achievable with Spanning Tree Protocol. See the IETF
for more MRP
information. See chapter
27 MRP Pre-Requisites and Application Examples
on page
Syntax
:
mrp
<domainId> client blocked-state { enable | disable }
mrp
<domainId> client link-interval <downInterval> <upInterval> [ <linkChangeCount> ]
mrp
<domainId> diag-clear
mrp
<domainId> manager link-change-react { enable | disable }
mrp
<domainId> manager media-redundancy { enable | disable }
mrp
<domainId> manager nonblocking-supported { enable | disable }
mrp
<domainId> manager priority <priority>
mrp
<domainId> manager test-interval <testInterval> [ <shortTestInterval> ]
mrp
<domainId> manager test-monitoring <count> [ <extendedCount> ]
mrp
<domainId> manager topology-change <topoChangeInterval> [ <topoChangeRepeatCount> ]
mrp
<domainId> name <domainName>
mrp
<domainId> ringport { primary | secondary } <port_type> <mrp_port>
mrp
<domainId> ringport-delete { primary | secondary }
mrp
<domainId> role { manager | client }
mrp
<domainId> status { enable | disable }
mrp
<domainId> uuid <domainUUID>
mrp
<domainId> vlan <vlanId>
mrp
domain delete <domainId>
mrp
domain new <domainId>
Parameters
: <1-2>
DomainID of Domain to modify
domain
Create/Delete MRP Domain
client Operate on an MRP Client
diag-clear Clear Diagnostic stats for MRP Domain
manager Operate on an MRP Manager
name Set name for Domain
ringport Set/Add Ringport
ringport-delete
Delete Ringport
role Set role in Domain to manager or client
status Enable/Disable a domain
uuid Set UUID for Domain
vlan Set VLAN for Domain
delete
Delete an MRP Domain
new
Create a new MRP Domain
<1-2>
Domain ID of Domain to be deleted
<1-2>
Domain ID of new Domain
blocked-state
Enable/Disable Blocked State support for MRP Client
link-interval
Set Client Link Intervals and Count for MRP Client
disable
Disable Client Blocked State support
enable
Enable Client Blocked State support (default)
<1-50>
Client Link Down Interval in ms (default=20)
<1-50>
Client Link Up Interval in ms (default=20)
