Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
87
of
272
Rapid Ring Port 2 State : Discarding
Entry Index : 2
Rapid Ring Role : Member
Rapid Ring Port 1 : 3
Rapid Ring Port 2 : 4
Rapid Ring Port 1 State : Discarding
Rapid Ring Port 2 State : Forwarding
Ring-to-Ring Role : Active
Ring-to-Ring Port : 5
Ring-to-Ring Port State : Discarding
SISPM1040-582-LRT(config)#
Messages
:
Message
:
Rapid-Chain only one set. :
make sure the ports are not be same.
Message
:
R_RING_ICLI_system_set error in port 8, STP is enable
: disable STP and any other ring technologies.
Message
:
The ports should not be same. :
make sure the ports are not be same.
Command
:
ring-to-ring
Description
:
Configure Ring to Ring parameters.
Note
: STP must be disabled.
Note
that Ring-to-Ring can
be configured via the front panel DIP switch (i.e., without using the Web UI or CLI). See the
Install
Guide
for details.
Syntax
:
ring-to-ring
role active port <port_type> <rport>
ring-to-ring
role backup port <port_type> <rport>
ring-to-ring
role disabled port <port_type> <rport>
Parameters
: role
Set role value
active role value active
backup role value backup
disabled role value disabled
port
Set port
GigabitEthernet 1 Gigabit Ethernet Port
<port_type_id> Port ID in 1/1-10
Example
: Configure and show
Ring-to- Ring
configuration:
SISPM1040-582-LRT(config)#
ring-to-ring role active port GigabitEthernet 1/8
SISPM1040-582-LRT(config)#
ring-to-ring role backup port GigabitEthernet 1/8
SISPM1040-582-LRT(config)#
end
SISPM1040-582-LRT#
show rapid-ring
Entry Index : 1
Rapid Ring Role : Rapid-Chain
Rapid Ring Port 1 : 5
Rapid Ring Port 2 : 6
Rapid Ring Port 1 State : Discarding
Rapid Ring Port 2 State : Discarding
Entry Index : 2
Rapid Ring Role : Member
Rapid Ring Port 1 : 3
Rapid Ring Port 2 : 4
Rapid Ring Port 1 State : Discarding
Rapid Ring Port 2 State : Forwarding
Ring-to-Ring Role : Backup
