Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
97
of
272
spanning-tree
Spanning Tree protocol. Table : configure –spanning-tree Commands:
Command
Function
aggregation
Aggregation mode
edge
Edge ports
mode
STP protocol mode
mst
STP bridge instance
recovery
The error recovery timeout
transmit
BPDUs to transmit
Command
:
aggregation
Description
:
Configure Spanning tree aggregation
Syntax
:
spanning-tree
aggregation
Parameters
: do
To run exec commands in config mode
end
Go back to EXEC mode
exit
Exit from current mode
help
Description of the interactive help system
no
Negate a command or set its defaults
spanning-tree
Spanning Tree protocol
auto-edge
Auto detect edge status
bpdu-guard
Enable/disable BPDU guard
edge
Edge port
link-type
Port link-type
mst
STP bridge instance
restricted-role
Port role is restricted (never root port)
restricted-tcn
Restrict topology change notifications
auto
Auto detect
point-to-point
Forced to point-to-point
shared
Forced to Shared
<0-7>
instance 0-7 (CIST=0, MST2=1...)
cost
STP Cost of this port
port-priority
STP priority of this port
<1-200000000>
Cost range
auto
Use auto cost
<0-240>
Range (lower higher priority)
<cr>
Example 1
:
Config mode:
SISPM1040-582-LRT(config)#
spanning-tree aggregation
SISPM1040-582-LRT(config-stp-aggr)#
?
do To run exec commands in config mode
end Go back to EXEC mode
exit Exit from current mode
help Description of the interactive help system
no Negate a command or set its defaults
spanning-tree Spanning Tree protocol
