Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
117
of
272
12.2 ERPS Config Mode Commands
Command
:
erps
Description
:
Configure Ethernet Ring Protection Switching.
Syntax
:
erps
<group> guard <guard_time_ms>
erps
<group> holdoff <holdoff_time_ms>
erps
<group> major port0 interface <port_type> <port0> port1 interface <port_type> <port1> [ interconnect ]
erps
<group> mep port0 sf <p0_sf> aps <p0_aps> port1 sf <p1_sf> aps <p1_aps>
erps
<group> revertive <wtr_time_minutes>
erps
<group> rpl { owner | neighbor } { port0 | port1 }
erps
<group> sub port0 interface <port_type> <port0> { { port1 interface <port_type> <port1> } | {
interconnect <major_ring_id> } } [ virtual-channel ]
erps
<group> topology-change propagate
erps
<group> version { 1 | 2 }
erps
<group> vlan { none | [ add | remove ] <vlans> }
Parameters
: 1-64
ERPS group number
guard
Guard
holdoff
Hold-off time
major
Major ring
mep
MEP
revertive
Revertive
rpl
Ring Protection Link
sub
Sub-ring
topology-change
Topology Change
version
Version
vlan
VLAN
10-2000
Guard time in 10 ms steps between 10 and 2000 ms
0-10000
Hold-off time in ms
port0
ERPS Port 0 interface
1-12
Wait-to-restore time in minutes
neighbor
Neighbor role
owner
Owner role
port0
ERPS Port 0 interface
propagate
Propagate
1
ERPS version 1
2
ERPS version 2
<vlan_list>
List of VLANs
add
Add to set of included VLANs
none
Do not include any VLANs
remove
Remove from set of included VLANs
interface
Ethernet interface
GigabitEthernet 1 Gigabit Ethernet Port
<port_type_id> Port ID in 1/1-10
interconnect
Major ring is interconnected
sf
Signal Fail
1-100
Index of Port 0 SignalFail MEP
