Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
255
of
272
Appendix B SFTP copy Commands
SFTP Client copy Commands - SSH/Telnet/Console - SolarWinds version 20.4.0.76
The SFTP commands were added at SISPM1040-582-LRT FW v7.20.0034 as described below.
See
chapter 5 Copy Commands
on page
for valid copy commands before FW v7.20.0034.
Note
: The ‘Always on PoE’ feature was incorrectly de-activated in FW v7.20.0034; to bring it back, after finishing
the FW upgrade procedure you must reload factory defaults, then copy running-config to startup-config. This will
be fixed in the next firmware version.
To reload factory defaults and then copy running-config to startup-config after the FW upgrade is complete:
SISPM1040-582-LRT#
reload defaults keep-ip
% Reloading defaults, attempting to keep IP address. Please stand by.
SISPM1040-582-LRT#
copy running-config startup-config
Building configuration... % Saving 1065 bytes to flash:startup-config
SISPM1040-582-LRT#
Secure File Transfer (SFTP) Setup
Switch Settings: RADIUS Authentication Using SSH PuTTY Port 22
Note
: The switch supports SFTP via “local, RADIUS and TACAS+” authentication credentials.
Note
: Switch FW v7.10.0034 and above supports “local, RADIUS, TACAS+, SSH” authentication credentials with
these SFTP features:
•
Transfer startup-config from SolarWinds to switch, using SFTP protocol
•
Transfer startup-config from switch to SolarWinds, using SFTP protocol
•
Transfer running-config from SolarWinds to switch, using SFTP protocol
•
Transfer running-config from switch to SolarWinds, using SFTP protocol
•
Transfer firmware from SolarWinds to switch, using SFTP protocol