Lantronix
SISPM1040-xxxx-L3 Install Guide
33855 Rev. A
33
Compliance and Safety Information
Declaration of Conformity
Manufacture’s Name: Lantronix, Inc.
Manufacture’s Address:
7535 Irvine Center Drive, Suite100, Irvine, CA 92618, USA
Declares that the products: SISPM1040-3166-L3, SISPM1040-2248-L3, and SISPM1040-3248-L3
Conform to the following Product Regulations:
Emission: EN 55032: 2015+A11:2020, CISPR 32: 2015+COR1:2016, EN IEC 61000-3-2:2019, EN 6100-3-3:
2013+A1: 2019, AS/NZS CISPR 32: 2015.
Immunity: EN 55024: 2010+A1: 2015. EN55035: 2017+A11: 2020 (IEC 61000-4-2: 2008; IEC 61000-4-3: 2020;
IEC 61000-4-4: 2012 ; IEC 61000-4-5: 2014+A1:2017; IEC 61000-4-6: 2013+COR1: 2015; IEC 61000-4-8: 2009;
IEC 61000-4-11: 2020).
Safety: UL 60950-1 2
nd
Ed., Issue Date: 2007-03-27, Revision Date: 2019-05-09.
CSA C22.2 No. 60950-1 – 2
nd
Ed. Issue Date: 2007-03-27 – Revision Date: 2014-10-01.
NEMA TS 2-2016 (2.2.7 Test Procedure: Transients, Temperature and Humidity) (2.2.8 Vibration Test) (2.2.9
Shock Test).
Relevant Standard(s) / Specifications: EN 55032: 2015+A11:2020 (Class A); CISPR 32: 2015+COR1:2016 (Class
A); EN 55024: 2010+A1: 2015; EN 55035: 2017+A11: 2020; EN IEC 61000-3-2: 2019; EN 61000-3-3: 2013+A1:
2019.
Measurement Procedures and Standards Used: 47 CFR FCC Part 15 Subpart B; ANSI C63.4: 2014; ICES-03
Issue 7; ANSI C63.4a: 2017.
With the technical construction on file at the above address, this product carries the CE Mark
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and
Standards(s).
Place: Minnetonka, Minnesota
Date: June 6, 2022
Signature:
Fathi Hakam
Full Name: Fathi Hakam
Position : Vice President of Engineering
FCC Regulations
FCC, Class A: This product has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This product generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s
instruction manual, may cause harmful interference with radio communications. Operation of this product in a
residential area is likely to cause harmful interference, in which case you will be required to correct the
interference at your own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
CE MARK DECLARATION OF CONFORMANCE FOR EMI AND SAFETY (EEC): This equipment has been
tested and found to comply with the protection requirements of European Emission Standard EN55022/EN61000-
3 and the Generic European Immunity Standard EN55024.