SM12XPA Quick Start Guide
33846 Rev. A
Page
1
of
2
SM12XPA
Quick Start Guide
Description
: The SM12XPA Fiber
Aggregation Switch is a managed Layer 3 (L3)
Multi-Gigabit Ethernet fiber switch offering powerful Layer 2 and basic Layer 3 features. It provides 340 Gbps switching
capacity with (12) 1G/10G SFP+ and (2) 1G/10G/25G SFP28 slots and (1) RJ-45 console port. The SM12XPA ships with
one AC power supply (100V-240V AC Input) in the box with the switch but not installed. An optional second Power
Supply is available (ordered separately).
Caution
: See the full Install Guide for important information on Safety Warnings & Cautions, Introduction, Description,
Overview, Ordering Information, Features, Specifications, Front Panel, Back Panel, LED Descriptions, Reset button,
Related Manuals, Installation, Package Contents, Mount in a 19-inch Rack or on a Desk or Shelf, Install & Remove SFPs,
Connect the AC Power Cord, Initial Switch Config, Troubleshooting, Power Supply, Regulatory Agency, & Warranty.
Front
Panel
: The front panel provides the ports, LEDs, and Reset button as shown and described below.
Back
Panel
: The back panel provides for power supplies and an airflow opening. The switch ships with one power
supply standard; order the secondary power supply module for the maximum power.
Caution
: Be sure to leave
adequate room for the airflow opening.
LED
Descriptions
: The LEDs on the front panel allow switch status checking and monitoring as follows:
System LED
: Indicates if the switch is powered up correctly or if there is a system alarm triggered for troubleshooting.
Port Status LEDs
: Indicate the current status of each port.
Reset button
: Press for a certain period of time to perform these tasks:
Reset switch
: Reboot and get the switch back to previously-saved configuration settings.
Restore switch to factory defaults
: Restore the switch to original factory default settings.
Note
: The table below tells which task is being performed by reading the LED behaviors while pressing the Reset button.
When the LED behaviors are correctly displayed, release the button.
Task to be Performed
Time Period of Pressing Button
SYS LED Behavior
Port Status LED Behavior
Enter POST Mode
Less than 2 seconds, then Power On --
--
Reboot Switch
2 ~10 seconds
Blinking Green
All Ports LEDs Off
Restore to Default
More than 10 seconds
Blinking Green
All Ports Solid On
