Lantronix
SM12XPA Web User Guide
33848 Rev. A
Page
190
of
473
Access Method
This page lets you configure access management parameters including HTTP/HTTPS, SNMP, and TELNET/SSH.
You can manage the switch over an Ethernet LAN, or over the Internet.
Note
: at SM12XPA FW v8.90.884 the
default changed to HTTPS, and HTTP will get redirected to HTTPS. Also, SSH stays enabled, Telnet stays disabled,
and you are given the option to enable Telnet.
Web Interface
To configure Access Method parameters in the web UI:
1.
Click Security, Management and Access Method.
2.
Select “on” in the Mode of Access Management Configuration.
3.
Click “Add New Entry”.
4.
Specify the VLAN ID, Start IP Address, End IP Address.
5.
Check an Access Management method (HTTP/HTTPS, SNMP, and TELNET/SSH) in the entry.
6.
Click Apply.
Figure 11-1.4: Access Method Configuration
Parameter descriptions
:
Mode
: Indicates the access management mode operation. Possible modes are:
On
: Enable access management mode operation.
Off
: Disable access management mode operation.
VLAN ID
: Indicates the VLAN ID for the access management entry.
Delete
: Check to delete the entry. It will be deleted during the next save.
Start IP address
: Indicates the start IP unicast address for the access management entry.
End IP address
: Indicates the end IP unicast address for the access management entry.
HTTP/HTTPS
: Indicates that the host can access the switch from HTTP/HTTPS interface if the host IP address
matches the IP address range provided in the entry.
SNMP
: Indicates that the host can access the switch from SNMP interface if the host IP address matches the IP
address range provided in the entry.
TELNET/SSH
: Indicates that the host can access the switch from TELNET/SSH interface if the host IP address
matches the IP address range provided in the entry.