Lantronix
SM12XPA Web User Guide
33848 Rev. A
Page
224
of
473
12. Access Control
Ports Configuration
Configure the ACL parameters (ACE) of each switch port. These parameters will affect frames received on a port
unless the frame matches a specific ACE.
To configure ACL Ports in the web UI:
1.
Click Access Control and Port Configuration.
2.
Specify parameter values for port ACL setting.
3.
Click Apply to save the settings.
4.
To cancel the settings, click the reset button. It will revert to previously saved values.
Figure 12-1: ACL Ports Configuration
Parameter descriptions
:
Port
: The logical port for the settings contained in the same row.
Policy ID
: Select the policy to apply to this port. Valid values are 1 - 8. The default value is 1.
Action
: Select whether forwarding is permitted ("Permit") or denied ("Deny"). The default value is "Permit".
Rate Limiter ID
: Select which rate limiter to apply on this port. The allowed values are Disabled or the values
1 - 16. The default value is "Disabled".
Port Redirect
: Select which port frames are redirected on. The allowed values are Disabled or a specific port
number and it can't be set when action is permitted. The default value is "Disabled".
Mirror
: Specify the mirror operation of this port. The allowed values are: Enabled: Frames received on the port
are mirrored. Disabled: Frames received on the port are not mirrored. The default value is "Disabled".
