Lantronix
SM12XPA Web User Guide
33848 Rev. A
Page
298
of
473
GCL
: A link to the Gate Control List parameter configuration.
Cycle
Time
: The Admin value of the gating cycle for the Port. The Admin Cycle Time variable is a rational
number of seconds, defined by value and a unit.
Cycle Time Value
: The Admin Cycle Time is defined by this number of units defined in the Unit field. The Admin
Cycle Time is a value in the range 1-999999999 and combined with the Cycle Time Unit the value will be in the
range 256-999999999 nanoseconds. The default value is 100 milliseconds.
Cycle Time Unit
: The Admin Cycle Time unit. May be milliseconds, microseconds or nanoseconds.
Cycle Time Extension
: An integer number of nanoseconds in the range 256-999999999, defining the maximum
amount of time by which the gating cycle for the Port is permitted to be extended when a new cycle
configuration is installed. The default value is 256 nanoseconds.
Base Time
: The Admin value of base time, expressed as an IEEE 1588 Precision Time Protocol (PTP) timescale.
Config Change
: The Configuration Change parameter signals the start of a configuration change. After a
successful configuration change, the configured Admin values will become the Oper values, which are displayed
on the Monitor > TSN > TAS webpage
If the value of Base Time is in the future, the configuration change will be executed at Base Time.
If Base Time is in the past, the configuration change will be executed as soon as possible. In practice it will be
within approximately 2 seconds, at a time which is an integral number of Cycle Time ahead of the configured
value of Base Time. This way, synchronization between schedules in elements across a scheduled network can
be maintained.
Buttons
Apply
: Click to save changes.
Reset
: Click to undo any changes made locally and revert to previously saved values.
You can click the linked text
Configure
to display ...
To be supplied.
