Lantronix
SM12XPA Web User Guide
33848 Rev. A
Page
322
of
473
Access-list
This page lets you view and set Router Access-List instances and parameters. Navigate to the System > OSPF >
Configuration > Area Authentication menu path to display the Router Access-List Configuration page:
Figure 19-3: Router Access-List Configuration
Parameter descriptions
:
Delete
: Click to delete an existing entry.
Name
: The name of the router access list.
Mode
: The access list operating mode.
Network Address
: The network address of the router access list.
Mask Length
: The netmask length of the router access list.
Buttons
Add New Entry
: Click to add a new entry to the table.
Apply : Click to save changes
.
Reset
: Click to undo any changes made locally and revert to previously saved values.
You can filter incoming and outgoing routes for a given IP interface using two Standard Access Lists - one for
input and one for output.
The standard Access List is a named, ordered list of pairs of IP prefix (IP address and IP mask length) and action.
The action can be
deny
or
permit
.
If an access list is defined, each route from the RIP message is checked against the list starting from the
first pair:
if it matches the first pair and the action is
permit
, the route is passed;
if the action is
deny
, the route is not passed. If the route does not match, the following pair is
considered.
If there is no pair that the route matches, the
deny
action is applied.
