Lantronix
SM12XPA Web User Guide
33848 Rev. A
Page
389
of
473
Offset-List
This page lets you create and configure RIP offset list parameters.
A RIP message includes a metric (number of hops) for each route. An ‘offset’ is an additional number that is
added to a metric to affect the cost of paths. The offset is set per interface and, for example, can reflect the
speed, delay, or some other quality of that specific interface. The relative cost of the interfaces can then be
adjusted as desired. You must set the offset for each interface (the default offset is 1).
Navigate to the System > RIP > Configuration > Offset-List menu path.
Figure 22-1.6: RIP Offset-List Configuration
Parameter descriptions
:
Delete
: Click the button to delete an existing entry from the table and the switch
.
VLAN ID
: Enter the VLAN ID for entry
.
Direction
: Enter the direction for entry
.
Access List Name
: Enter the name of the access list for entry
.
Offset Metric
: Set the offset for each interface (the default offset is 1).
Buttons
Add New Entry
: Click to add a new entry to the table.
Apply
: Click to save changes.
Reset
: Click to undo any changes made locally and revert to previously saved values.
