Lantronix
SM12XPA Web User Guide
33848 Rev. A
Page
431
of
473
PoE Auto Checking “AutoFill” Feature
When you enable Auto power reset (PoE auto checking) in DMS, the IP addresses of the connected devices are
automatically filled on the Auto Power Reset configuration page.
1.
Configure the “PoE Auto Checking” parameter at Switch > PoE Management > PoE Auto Checking. The
default value of the “Failure Action” parameter is “Reboot Remote PD”. Note that “PoE Auto Checking” is
called “PoE Auto Power Reset” in earlier firmware versions.
2.
Configure PoE parameters at DMS > Graphical Monitoring > Topology View. Left click on the switch icon to
display its device configuration popup. Click the PoE Config (
) icon to display the PoE Auto Checking
pane: